Pentair® SuperFlo, SuperFlo VS SuperMax Pump Seal Kit made by Pentair®
Original Pentair® SuperFlo and Superflo VS SuperMax Pump Seal Kit 356197 Includes
- Seal Plate O-ring – P/N 355619Z
- Shaft Seal Assembly (salt/ozone resistant): P/N 356210S- 2A(Ceramic Seal), 2B(Spring Seal)
- Diffuser O-ring: P/N 355030Z
- Strainer Pot Lid O-ring: P/N 357255Z
- Drain Plug O-rings (Quantity 2): P/N 192115Z
Original Pentair® SuperFlo and Superflo VS SuperMax Pump Seal Kit 356197 Installation:
First you should remove the old shaft sealRemoving the old shaft seal:
- Refer to the pump Installation and User’s Guide and complete all prerequisite disassembly instructions.
- Hold the motor shaft in place at the rear of the motor and unscrew the impeller counter-clockwise. Remove it from the motor shaft.
- Using a pair of pliers, remove the old Spring Seal from the impeller shaft.Note: When removing the Spring Seal the inner sleeve of the seal may stick to the shaft. Ensure it is removed before installing the new Spring Seal.
- Using a 9/16-inch wrench, remove the four bolts securing the seal plate to the motor. Set the motor aside.
- Place the Seal Plate face down on a flat surface and tap out the old Ceramic Seal with a flat-blade screwdriver (Figure A).
Then new shaft seal should be installed.Installing the new shaft seal:
- Flip the seal plate over and thoroughly clean the seal cavity.
- Using the silicone lubricant provided in this kit, lightly lubricate the outside rubber surface of the new Ceramic Seal.
- With the White Face upwards, firmly press the new Ceramic Seal into the seal plate cavity with your thumbs (Figure B).
- Using a clean cloth, thoroughly clean the seal face.
- Ensure the side marked ‘UP’ is on top and install the seal plate onto the motor. Tighten the four bolts to 75-80 in-lbs. (86-92 kg/ cm).
- With the Flat Face towards the impeller, slide the new Spring Seal onto the impeller shaft (Figure C).
- Using a clean cloth, thoroughly clean the seal face.
- Hold the motor shaft in place at the rear of the motor and hand tighten the impeller clockwise onto the motor shaft.
- Refer to the pump Installation and User’s Guide and complete all remaining reassembly instructions.
Please note that certain manufacturers - including but not limited to Pentair® (TradeGrade products), Jandy®/Fluidra® (Trade Series Exclusive products), and Hayward® (Expert Line products) - do not honor manufacturer warranties for specific products purchased online.
We sells only brand new products; however, we do not provide any warranty coverage ourselves, nor do we guarantee manufacturer warranty eligibility.
It is the sole responsibility of the purchaser to verify whether a product qualifies for warranty coverage prior to making a purchase.
We strongly recommend contacting the product manufacturer directly to confirm warranty eligibility.
By completing your purchase, you acknowledge and agree that we are not liable for warranty coverage or support if the manufacturer refuses to honor the warranty based on their policies.
We sells only brand new products; however, we do not provide any warranty coverage ourselves, nor do we guarantee manufacturer warranty eligibility.
It is the sole responsibility of the purchaser to verify whether a product qualifies for warranty coverage prior to making a purchase.
We strongly recommend contacting the product manufacturer directly to confirm warranty eligibility.
By completing your purchase, you acknowledge and agree that we are not liable for warranty coverage or support if the manufacturer refuses to honor the warranty based on their policies.
Reviews
There are no reviews yet.